Cliff Polubinsky
Contributor

I'm about to sand a group of boxes. I'm planning on using a 220 grit sanding mop on the drill press. Cliff

Thomas, Instead of clamping the duct to the dust port I use the 5" magport fittings. http://magport.net. When I switch from one mode to another...

Infinity Tools has a dado jig that works well. https://www.infinitytools.com/infinity-tools-precision-router-dado-jig Cliff

If the Dewalt clamps fit then the low profile clamps that Lee Valley sells should fit as well. I have both Dewalt and Lee Valley clamps and use the...

Jim, You're probably aware of this but for those who aren't, always mill equally from both sides. Milling unequally can result in a moisture...

Jamie, I have the mobility kit on my 10-347 and it doesn't raise the saw much. Maybe an inch. The height hasn't been a problem so far. Cliff