Neil Strong
Contributor

This is the , which I would press if this forum software had it...

This is the , which I would press if this forum software had it.

Cindy Drozda also has a video segment on doing the 40/40 grind on a platform. If you are not familiar with that grind it is always good to see how...

I hesitate to engage in this discussion with an coring expert like Reed participating, but if that was the response from Mr Hunter I think it absurd!...

+1 for the McNaughton. I also had the Woodcut but found it less flexible than the McNaughton.

If you can only have one, go with a chainsaw. You can't take a bandsaw out to cut up a fallen/felled tree. Immediately ripping freshly...

I wear pilot overalls. Primarily worn to keep the dust out of my clothing underneath as I'm an asthmatic and have to avoid fine wood dust and mould...

This is the , which I would press if this forum software had it...

Agreed, Prashun, I added some extra words with an edit to my previous post, thanks.

This is the , which I would press if this forum software had it... for your explanation, which all seems logical to me and particularly if sharpening...

Prashun, it might be helpful for others if you could explain the dangers of using a V-arm to sharpen a SRG. Never used one myself and have always...

You can't get enough temperature off a bench grinder to spoil the temper in HSS. Any colour change is just cosmetic. The wings on my SRG have...

Of the many tons of shavings that I have produced over the years I've never needed to tip any of it into the garbage. I have a long list of people on...

This is the , which I would press if this forum software had it...:)

According to Olivers Woodturning (see here) the Nova jaw sets "will also fit the Robert Sorby and Record Power chucks. I presume from that that...

This is the , which I would press if this forum software had it...;)