Chris Parks
Member

Thanks Matt. I was the Australian agent for Clearvue and introduced the product to Oz with success but the current agent has been forced to stop...

A comment and a question, if the cyclone is exhausting to atmosphere then I have found a typical Grizzly style short cone works as well as a long...

With no disrespect to Matt his post illustrates my point regarding how we look at sizing dust extractors. In the great big scheme of things 1-1/2HP...

As long as the HP is adequate to turn the impeller at full speed the HP is not the important factor, the impeller size is. If a 13" impeller is...

FPS is a mistake, it should be CFM.

1000 fps is the delta that Bill Pentz arrived at and it has become the default number that is aimed. Actually my statement on 6" is what we use in Oz...

1000 FPS is easy to get, use 6" duct and ports on the machine and a 15" impeller at 60hz/3450RPM and the job is done. No magic is involved, it simply...

Thanks for the feedback and your experience in related fields. BobL who does all the research on that forum is a physics professor who designed and...

The Australian Woodworking forum has a lot of information and well researched data on measuring air flow and it is the only place I know of that has...

On a closed cabinet like a bandsaw it is all about making sure there is an additional port allowing replacement air in at the same rate as the...

I should clarify what I wrote above, when I say 3 phase I am saying that a three phase motor is used by utilising a VFD from a single phase power...

Yes, but the option is still there using any three phase DE. If Oneida were really serious they would not sell single phase machines at all as they...

That can be done automatically with a VFD if it is programmed correctly. I did a commercial installation where the system did exactly that but don't...

Any 3 phase dust extractor with a VFD will do exactly the same thing including Cleavue. Personally I would not buy a single phase dust extractor if...

That doc does not appear to be for the current A3 series of machine.

About two minutes.

Everyone has their own individual take on our approach to working but I think most of us tend to over complicate things and be to clever for our own...

Here are the pics of how I can set up a parallel guide using two fences and a length of aluminium extrusion. It can have a low or high position which...

The problem with that is I can't see how it helps to have a measurement system on the F&F jig if the rip fence is used as a stop and my rip fence has...

This idea has been floating around in my head for a while and though I haven't tried it I think the following may work. Set up the CC fences the...

Two fences set up as a parallel guide system with my apologies for the poor photo. Looking at the photo it is obvious more explanation and and more...

I have built a system using 20 series extrusion using the same basic ideas as Derek but it is digital and a bit clunky. My saw came without the...