Derek Arita
Contributor

I have the old Delta cast iron lathe. It has a vfd so it requires 240 volt single or three phase. It has a variable speed drive in the base. I had stripped and painted it but i put it outside when I got my metal lathe so the ways have surface rust all over. It is on the heavy sheet metal cabinet. It is probably about 1950. I replaced most of the bearings. You could switch the motor to single phase if you wanted to.
This is the same model
http://vintagemachinery.org/photoind...l.aspx?id=9580

If you want to sell the PM jointer, let me know your location and price.

Thanks, Dan West02