Lots of recommendations for something else, and if you read my post, I already bought the Bora. Guess I made a big mistake, but planning on using it...
If that is the only compressor you will have, the tank is way too small. I have the smaller version that I use under my workbench for very minor air...
Are there any zoning laws or ordinances? Insurance issues with your carrier? Fire marshall approval? Cost to get electricity and electrical capacity...
Maybe I didn't make the best choice, time will tell. I'm not worried about maneuverability in the shop. When I had a full time shop, we used a skate...
Explaining to new woodturners that standing by a spinning block of wood is extremely dangerous is far from sensationalizing. It's a concern for their...
Not sure that's a good idea. It's not like bondo and using it to fill tear out could easily be a problem over the years. It's only made to fill tiny...
That looks like it has a manual feed crank? That's very unusual. I can't see any ball bearings in that breakdown picture, maybe all sleeve bearings?...
Find latest posts
View Articles
View Blog Entries