Steven O Smith
Contributor

Sounds reasonable, except I don't like table saws, I use a bandsaw. The spline should be easy to do with a router though.

That makes great sense Michael. Thanks.

I'm not following the part about the spline in the *back*. I was picturing a spline being similar to a loose tenon. I don't have a Domino. The...

I have an S45N, it sounds like you have the same miter slot. Mine is 12mm wide (measure yours). I bought a decent miter gauge, removed the 3/4" bar...

Yes, I think pegged tenons will be a good plan.

I recently tried hot glue. Don't use it if your bit will be coming through the side of the stock and into the glue. You end up with a blob of glue...

I wonder if rotating more slowly and moving the router faster would be better. Using the rotary axis more as a positioner than a lathe. Steve

I do hand and power woodworking, blacksmithing and metal machining, hobbies all and at home. I was greatly amused when I had to fill out a form at my...

Looking forward to the video.

Thanks for the details, I will definitely keep reading.