Todd Trebuna
Contributor

Tough call. I don't play so it's virtually impossible for me to win. But were I to magically win, I would sell my house and move to a smaller house...

That was on my very short list too, Brian. I decided instead to go SawStop, but everything I read on that saw was positive.

Finished the Tea Box for my wife last week. Started a glue up in Teak for a shower Seat for her (she is struggling with IBS and Chronic Fatigue for...

I have the Jessem Table with the Rout-R-Lift II. Been using a Bosch 1617 for the past 8 years with acceptable results. I have used several box...

I'm having trouble understanding, but it sounds like you are making a single tail in each corner with a pin on either side. Which I would think is...

I bought one from that time frame about 6-7 years ago. I paid the same. It runs every time I hit the switch. I did take it apart and clean it and...

Awesome. I have all these tools. except the torch. The Mrs. won't let me around anything that I have to "light" that also needs "fuel". women....

Your sadness at cutting down this fine tree, lends itself well to your character. It is a magnificent tree and if it had a consciousness, I think it...

Harbor Freight brass on one end, rubber on the other. Works great and I think it was 5 bucks.

Hi Frederick. It's glued down. I kept glue away from the edges to avoid squeeze out, so it looks like there is a more noticeable gap in the pics...

LOL...indeed. Over 20 years of making dust and noise. I have a FT job, so woodworking is a hobby, But I really appreciated the pace and the peace....

I bought the Marbles Camp axe after doing some research. It got very good reviews by a lot of actual hatchet connoisseurs, which I am not. Was...

I’ve had a Jesse router table for 7 or 8 years. I threaded casters into the legs, but the threaded inserts in the legs came out of the legs on two...

6 dollars<lifetime of regret.

I use both a "rag in a can" or a chunk of paraffin, cut off a block of paraffin. Trying to decide which I like better.

I have the Jessem table and lift. I've had the Bosch 1617 mounted in it for awhile. I haven't had any problems. I'm not someone who uses it a ton,...

Really want to see some builds.

Pm sent on compass if not spoken for.

I have the same setup. I too have noticed the Dog holes deforming from the Holdfasts. I will tell you though, that what really changed the holding...

I recently bought a sheet of 3/4 inch walnut Ply. It is probably more towards 15/16ths and I was impressed with the packing. They actually shipped...

I've been working on an end table for my wife. She makes beautiful things with thread. And generates alot of clutter. The first two pics are of...

I have a 22 or 24 inch Blackstone that I absolutely love. My grill in our RV finally gave up the ghost, so I replaced it with a griddle. I Keep it...

Thanks. I also got "Willow" a Goghnut. It's guaranteed for life and holding up well. If the dog chews through it, they will be replace it free of...

I use Bahco files also. I use a combination head light and magnification glasses because I need readers. The only gadget I have is the “Veritas”...

Very Nice. Hoping for something like that next Christmas.

I've built two work benches. My current is 6x2. Wish I had another 6 inches of width. Don't think I could fit another 2 feet of length. I use...