Bill Orbine
Member

A magnet will tell. I wonder if the base is casted and then plated.

Do more filtration area and in stages like an over head air cleaner. You could take one of those and connect it to the table.

Seems like you thought of all of your possible options and using the skilsaw seems to be the best one. Considering how many of those 14' slabs you...

On a couple handyman jobs the leaks, if not the drain basin or liner, tends to be in the corner..... Where one wall meets the other. The walls meet...

Cheap.... better hurry up!

Have you read the motor plate on your existing? Does it say anything like duty cycle or time rating?

Go ahead and buy it! I could use a real good laugh! Seriously, You can buy a much better old iron such as Rockwell or Dewalt for much less than...

About time! You'll find a variety of uses for the small router now that you have one. Now..... Time to buy a wide belt sander....

Speed stated on cutters are maximum speeds. Not necessarily optimal. Many cutters I run are below max speed, but never over.

That magnetic switch will replace the whole LVC system assuming you have single phase 220 less than three up motor. BUT....Your "starting to fail"...

On LVC system, the existing switch are momentary switches with on normally open and off normally closed. However, you stated your system is...

Double up the veneer core plywood substrate in a glue and screw sandwich and cleats both sides and rear. I've done told like that and they've held...

If you have slides that aren't gravity assisted or self closing, then the slides may have worn, damaged or missing catches. For example, the...

Isn't the cabinet steel? Repair the flange! It helps with table alignment and stability.

Your memory of the 1917 game a bit fuzzy? 101 years ago! Just how old are you?:eek:

Oh I don't know.... I thought Lowe's is making a pretty good push with the Craftsman lineup. I thought the looks was very appealing though it was...

Can't complain about the price and it is worth to see what you are missing, if anything at all. Just taking baby steps! So I'd go for it if I were...

It is critical to have your machine setup properly and maintained to avoid alignment issues. Not speaking of just the setup for the profile but the...

There is a hack saw and there is a hacked saw. Some one cut into the base and cabinet of this machine. I'd walk away from this one!

Does your garage door open when you try to turn on the dust collector? Vice Versa? I've heard of remote erroneously swapped before.

Costco had the Feit at $20.00 per 4 footer last holiday. Two packs sale ends tomorrow 1/27/19. 4000 lumens at 4000k. Bright and greater color for...

The other option is to do your copes 1st and run the shorter pieces on a sled that has a longer guide on the fences. The down side with using the...

These are large tiles? I think the trowels you will use to lay the mortar and set the tiles makes using the transistion piece moot.

Is this going to be attached to the wall or is it to sit on top of something? You can do without the aprons based on the joinery you use for...