• Dick Mahany's Avatar
    05-04-2021, 12:43 PM
    I wasn't able to use the long, straight duct for my inlet. I think I broke every rule in the book and had a home made 45 wye right at the inlet. ...
    14 replies | 857 view(s)
  • Dick Mahany's Avatar
    04-17-2021, 7:07 PM
    Dick Mahany replied to a thread Steady rests in Turner's Forum
    I think it all depends on the type and size of the work one plans on turning. I wasn't sure if I would be doing much hollowing, so before I sank a...
    16 replies | 1719 view(s)
  • Dick Mahany's Avatar
    04-09-2021, 11:31 AM
    I saw a tool cart on a Glendale Turners site years ago by B. Loitz that I liked. Based on his pic, I set out to build one that would also hold all...
    9 replies | 1689 view(s)
No More Results

1 Visitor Messages

  1. View Conversation
    I saw your old post (May 9, 2009) about the lighting fixture you made for your Jet 1642 lathe. Do you have the dimensions you used?
Showing Visitor Messages 1 to 1 of 1
About Dick Mahany

Basic Information

About Dick Mahany
Palm Springs, CA
Ex operations guy - Singapore and Siicon Valley Semiconductor Equipment


Dick Mahany.


Total Posts
Total Posts
Posts Per Day
Total Albums
Total Photos
Visitor Messages
Total Messages
Most Recent Message
06-28-2015 9:37 PM
General Information
Last Activity
Yesterday 5:04 PM
Join Date

2 Friends

  1. Greg Ketell Greg Ketell is offline


    • Send a message via AIM to Greg Ketell
    • Send a message via Yahoo to Greg Ketell
    Greg Ketell
  2. Moshe Eshel Moshe Eshel is offline


    Moshe Eshel
Showing Friends 1 to 2 of 2