Tab Content
  • Rob Price's Avatar
    10-17-2018, 10:45 AM
    Rob Price replied to a thread Lychee Calabash in Turner's Forum
    Kyle, no foot. I tried to carry the curve further down than usual to add some lift- there is a flat area of about 2 on the bottom- so not truly...
    5 replies | 433 view(s)
  • Rob Price's Avatar
    10-14-2018, 9:08 PM
    We were fortunate to go on a family vacation to Hawaii earlier in the year and I was able to ship back some blanks. This was a piece of Lychee....
    5 replies | 433 view(s)
  • Rob Price's Avatar
    10-14-2018, 9:04 PM
    Rob Price replied to a thread Little Dish in Turner's Forum
    Very nice figure in that piece.
    2 replies | 349 view(s)
  • Rob Price's Avatar
    10-14-2018, 9:03 PM
    For me- natural edge bowls I turn once, 1/4-3/8" thin, and let them warp. Since the rim is already uneven the warping just adds to the organic look....
    10 replies | 600 view(s)
  • Rob Price's Avatar
    10-11-2018, 5:54 PM
    Is Leland Cypress any good for turning? Some friend had a big one go down with Hurricane Micheal last night. Similar to cook pine?
    2 replies | 166 view(s)
  • Rob Price's Avatar
    10-08-2018, 9:16 PM
    I have a 1/2 skew and I ground the cutting edge to the same angle as my dovetail jaws. I use it on its side as a negative rake scraper. I can use it...
    15 replies | 1083 view(s)
  • Rob Price's Avatar
    10-08-2018, 9:07 PM
    Rob Price replied to a thread Easy finish in Turner's Forum
    Ive recently started using Parfix CA glue as a finish. One coat, wipe on wipe off. Let it dry for a few minutes or hit with accelerator then buff. ...
    3 replies | 353 view(s)
No More Results
About Rob Price

Basic Information

About Rob Price
Location:
Northeast Georgia

Signature


Where did I put that?

Statistics


Total Posts
Total Posts
820
Posts Per Day
0.23
General Information
Last Activity
10-19-2018 9:10 AM
Join Date
02-20-2009

2 Friends

  1. Jay MacDougall Jay MacDougall is offline

    Member

    Jay MacDougall
  2. Jim Underwood Jim Underwood is offline

    Contributor

    Jim Underwood
Showing Friends 1 to 2 of 2