No More Results

3 Visitor Messages

  1. Bernie Weishapl
    View Conversation
    Ricc sorry I didn't get back with you sooner. I haven't been on here in a while due to eye problems and travel. Generally on those I get $22 at the Gallery and the Cultural Center. Again I apologize. Haven't been able to be in the shop due to my eyes which I am happy to say in September got the full clearance to get back at it. Anyway will probably be on here a little more now that I can actually do some work. LOL
  2. Thomas Canfield
    View Conversation
    Ricc,

    Ricc, I just use the standard tip. You should practice on some other prepared wood to learn the feel. I usually sign after a coat of finish, but it works well also before applying finish. A "shallow" signing will take finish differently and be a lot more visable after finishing. You can either rub the signing with your fingers or last grit sandpaper to remove any raised edges. Tom
  3. Nate Davey
    View Conversation
    Hey Ric,

    I don't have any plans, just looked at pictures of others on the board here and then worked it to fit my lathe. Fortunately, I have a buddy who owns a ShopBot, so the rings were easy.
Showing Visitor Messages 1 to 3 of 3
About Ricc Havens

Basic Information

About Ricc Havens
Location:
Elkhart, IN
Occupation:
Self employed

Statistics


Total Posts
Total Posts
416
Posts Per Day
0.06
Visitor Messages
Total Messages
3
Most Recent Message
12-18-2015 7:35 PM
General Information
Last Activity
Yesterday 8:57 AM
Join Date
03-26-2005

3 Friends

Showing Friends 1 to 3 of 3