No More Results

3 Visitor Messages

  1. View Conversation
    Ricc sorry I didn't get back with you sooner. I haven't been on here in a while due to eye problems and travel. Generally on those I get $22 at the Gallery and the Cultural Center. Again I apologize. Haven't been able to be in the shop due to my eyes which I am happy to say in September got the full clearance to get back at it. Anyway will probably be on here a little more now that I can actually do some work. LOL
  2. View Conversation

    Ricc, I just use the standard tip. You should practice on some other prepared wood to learn the feel. I usually sign after a coat of finish, but it works well also before applying finish. A "shallow" signing will take finish differently and be a lot more visable after finishing. You can either rub the signing with your fingers or last grit sandpaper to remove any raised edges. Tom
  3. View Conversation
    Hey Ric,

    I don't have any plans, just looked at pictures of others on the board here and then worked it to fit my lathe. Fortunately, I have a buddy who owns a ShopBot, so the rings were easy.
Showing Visitor Messages 1 to 3 of 3
About Ricc Havens

Basic Information

About Ricc Havens
Elkhart, IN
Self employed


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
12-18-2015 8:35 PM
General Information
Last Activity
Yesterday 10:04 AM
Join Date

3 Friends

Showing Friends 1 to 3 of 3