Rob Young
Contributor

The parts will not be as strong as injection molded parts. The layer lines are an inherent weakness. There are discussions of tempering and other...

I also have a Prusa i3MK3 along with two Ender 3's and a Photon SLA printer. While they mostly get used at work for prototyping cases, making custom...

I've not tried on a large, high-use, surface like a table or desk but on some test pieces and a few small boxes, plane old Plaster of Paris worked...

Card scraper for the flat surfaces. When you say "vice faces" I'm going to assume you mean the part that is going to bear against things in the...

Sanding all surfaces to the same grit prior to applying a dye helps keep colors a bit more even. End grain you might want to take up another grit,...