-
Older Activity
-
Yesterday, 10:43 PM
Fold slide systems usually require weight bearing headers. These openings were about 10’ wide. Notice the substantial header.
Lift and Slide...
13 replies | 679 view(s)
-
03-28-2024, 9:07 AM
Michael, the Kolle machine had a removable stop with locating dowels that could be set on either side of the table at various locations.
you could...
15 replies | 943 view(s)
-
03-27-2024, 6:30 PM
Bill, doweling has to be accurate. The euro machines have spacing stops for the drilling head of 15mm, 20mm 32mm etc. so you butt the stile to the...
15 replies | 943 view(s)
-
03-26-2024, 9:35 PM
John, I’ve had a few horizontal drills. Started out in the 70s with a Newton. Only doing cabinets at the time. It wasn’t too bad and later went to a...
15 replies | 943 view(s)
-
03-26-2024, 7:59 PM
That SCM shaper is a good deal. Far better than any others discussed, new or used. It even has a tenoning hood for running cutters larger than 250mm....
75 replies | 4462 view(s)
-
03-26-2024, 12:33 PM
Yes, the rebate and groove sounds like a good idea.
34 replies | 1714 view(s)
-
03-25-2024, 9:14 PM
John, I would picture a section something like this. Glue and clamp with PVA double coating the ply. Would be plenty strong.
34 replies | 1714 view(s)
-
03-25-2024, 8:34 PM
Might be best to make a sample corner of each. I’ve never done these but think I would prefer a mitered corner and treat it like thick edge banding....
34 replies | 1714 view(s)
-
03-07-2024, 3:58 PM
If I am understanding your constitution you have full thickness stave core stiles - 1” thick rails centered then vertical planks on to these to end...
11 replies | 868 view(s)
About Joe Calhoon
- Location:
- Ouray Colorado
Total Posts
- Total Posts
- 1,393
- Posts Per Day
- 0.25
Visitor Messages
- Total Messages
- 6
- Most Recent Message
- 01-29-2022 9:06 AM
General Information
- Last Activity
- Yesterday 10:43 PM
- Join Date
- 12-24-2008
2 Friends
Showing Friends 1 to 2 of 2