Brian Tymchak
Contributor

I got a follow up today from the Fidelity scammers. Guess I'm popular!

Welcome to the Creek Raye! I had the same initial negative interpretation of your post that a few did. The moral of the story is that you...

+1. That is a good idea. Thanks!

This is pretty interesting. Watched a Youtube video of guy using the sealer and topcoat on a guitar. Pretty impressive to go from stain to buffed...

I would say it depends on the weight of the top. From your explanation it sounds like the base may be fairly lightweight in construction if you can...

Thanks William. Appreciate the details in your reply. Learned something today so I can sleep tonight.

Thanks for the post Lewis. That was extremely interesting.

I have not done any veneering of consequence but I have used a fair amount of plastic laminate. So I ask this question as much to satisfy my own...

Geesh, not sure how I missed this before. Beautiful work Jay! Love cherry+maple and you have a great balance of feature panels to the overall...

I'd forgotten about their bin. I remember when watching the show that it might be a good way to go. Good luck with that strategy..;) I've...

Thanks Justin!

My makita 1013 has a depth stop so I would assume all modern MSs do. However, I would advise that it provides a rough vs precision depth for...

Wow! Amazing figure. Wish I had a source for stock like that. I think I might feature that as door panels in a very special cabinet. If you...

A timely thread. I built something similar. But it is heavy to move when I need access to the irrigation shutoff behind it. And I...

Thanks for that idea Jay!

Not just Woodpeckers. I was shopping for shellac flakes recently. Found something I wanted to try on shellac.net. Check out the shipping prices...

When you get the brake off the blade, check the blade plate closely. It may have been bent slightly by the sudden stop. The blade we pulled off the...

There is an XPrize contest for mask design - https://www.xprize.org/challenge/nextgenmask I think the winner was to be announced at EOY 2020 but I...

Delta has a terrible reputation right now, and has for several years, regarding tool quality and customer service. I recommend going with a...

Inevitable. For all the environmental reasons cited plus some like razor thin profit margins in agriculture, disruptions due to weather impacts,...

Your grocery store has carpeting?? I can't imagine a worse floor covering for that env.

Glad you're OK Mike. I had one misfire on me while I was volunteering at the local furniture bank. With hearing protection on I never heard the...

Worth it to get a paint scraper and scrape off what you can before running thru jointer/planer.

Look like t-nuts that slide in slots in t track. I have nuts like these on my incra router table fence.

You mention that the pieces had been rough milled. This implies to me that further milling (joint/plane/cut) is necessary. I would just scrape the...

Thanks Melvin. Not fully decided, but I'd say it is my front runner at this point. Although I haven't done a lot of research yet. It's not just...

Thanks Russell. I intended to also ask about wear and tear but forgot before hitting send. I'm sure I won't do much heavy or high volume work with...

I have no info for you Russell, but I'm considering buying the 18-36. Can you tell me how old that lathe is? Thanks!