Brian Tymchak
Contributor

It's illegal in Ohio too. Section 6101.81 | Destruction, injury, removal of survey marks prohibited. No person shall willfully destroy, injure, or...

Ah, I didn't realize they had made a floor model of the Viking. I wonder why as I remember when the Viking came out it being touted as the bench...

Thanks Tom. Yes it does. That one is a bit pricey! Wonder what might make it worth the cost vs the klingspor at about 1/2 the cost.

The full height version is called the Voyager. The base and column are quite heavy. I had no issues with stability while I had it directly on the...

It takes just a few minutes for a bank to verify if the check is good before cashing it.

That's looking pretty good Jim. Green with envy. BTW, how did the minisplit do vs the summer heat and humidity?

Thanks guys! Both of those suggestions look promising.

I agree with Stephen. I have a 735 (since 2006) and have thought about putting a spiral head in it. Many say that it runs quieter which is nice,...

I'm having a hard time envisioning what you are building. I'm not in construction but I know enough to do some DIY concrete. Working backwards...

If drawer width is what you want to optimize, you could use a thin web frame below the drawer to slide on, instead of a slide or runner.

I have cut a slice off 3/4 stock about 2" wide. But it was a bit squirrely. I used a Gripper with the side leg, a push stick in the left hand to...

Oops. Should have been 3x12. Guess I needed another cup of tea this morning. Sagulator still calls the sag of 0.10 in over the span acceptable. ...

Sagulater says that a 4x12 doug fir beam spanning 12' will have acceptable sag bearing a uniform load of 10,000 lbs over the span. Not sure how to...

White oak can be quite brown. I've seen red and white oak nearly the same color and mixed in the same bunk. The definitive tells are: 1. The end...

IMHO, THE one true editor for real programmers is vi. After vi, editors just got clunky and bloated.

I think the TOS prevents me from sharing any that I've come up with.... ;)

PwnCNC just released a video showing their tool changer. It's in the last third of the video. https://youtu.be/IFOkSZM4JEs?si=6Ew4pXiDCISCG2N1

Yes, you need a backer board. I think most of us that use a dado stack add a sacrificial fence to our miter fence to be that backer board. I have...

Glue spreaders....;)

Don't have the Centipede but I've considered it. Just seems a little too pricey. Hoping to catch a sale or something. I would put a full sheet...

I've used Deer and Rabbit repellent (Home Depot) on Lillys and petunias for the last several years and have had no more problems. They eat...

Having a relatively small shop (~500 sf) has instilled a bit of discipline in me to keep the clutter down but I certainly could do better. Hardwood...

+1. ....cha cha cha.

Also post a close up photo of the dado stack showing the tooth profile of the outer blades.

Wow! The curl in that piece is incredible! Congrats on a great job.

I found the Hock scratch kit a quick way to get scratching. For not too much money you can avoid figuring out how to fix a home made scratch profile...

As others have mentioned, with all the electronics on board these days, repairs costs have grown over the years relatively way more expensive than...

+3 or 4. If it's just a few inches, I would carve, file, scratch the profile.