Brian Tymchak
Contributor

Bernie, what brand / product are you using? My original system was JDS but they dropped the product, probably because of the problems.

I don't have an aftermarket source for you, but I have a word of caution. I have the Nova Voyager that has that sliding depth stop. Easy to...

You could make it like a wood floor, with pieces of varying lengths, maybe 3" in width, attached to a base, such that the joints stagger. Then it...

I don't see this as that much extra effort on the vendor or IRS. In this day and age of technology, I believe that the actual work to report and...

Beautiful bowl Paul! Never though about cutting across the crotch like that to center the feather. I got a piece of a flowering cherry from my...

Those pancake compressors are so noIsy. I got one many years ago and only used it a couple times. It sat for several years and then I donated it to...

I recommend you look into positive air pressure masks. I have the Trend Airshield Pro which I use quite bit when I do dusty things like sanding...

About 15 years ago I set my shop up with the low voltage blast gate switches for the DC. It worked pretty well and was a nice convenience. The...

Did you note what the calorie counts were for the different levels of milk fat content? I think that would be interesting to know.

Although it is but a single data point, the store brand granola cereal I like has inreased by well over 100%. No way all that increase can be...

I had a couple pieces of River Birch with similar shape. I ended up slicing those into platter blanks, about 2" thick, thinking that would be the...

When you resawed the boards, did you also plane the opposing sides so that you had relatively equivalent moisture levels exposed to air when you...

Do you know if they actually have BB in stock? I haven't checked in the last few weeks, but my favorite local supplier couldn't even order it from...

A few thoughts. 1. Are you bottoming the bit in the collet? It should not be. That can lead to the bit not being properly secured in the collet....

I had the same question in mind and looked it up. Doesn't appear to be relevant to the issue raised by the OP. ...

Does melamine need to be scuff sanded before priming?

Not sure how much surface you have there, but one way to apply a thinner coat is to rag it on vs brushing. Bit of a learning curve to know just how...

Love the design of that desk!

Definitely don't trim the case itself. If you want to move it in the future you've created another problem. I might be inclined to build a base a...

+1. Cha cha cha...

OK, I'll bite...What is a blotter??

Nicely done Mike. I've never seen avocado. Pretty wood. Saw your note and just checked prices at my favorite sawmill. Looks like hardwoods,...