Brian Tymchak
Contributor

Hi Doug! Thanks again for the cat pattern and for the mobile idea. Given how pressed for time I was to do 50 dozen I think I need to make decisions...

If you really strive to do your project with lumber from the same tree (difficult/impossible unless you work directly with the sawmill) I would...

Thanks all for the kind comments. Us too. In fact my wife, who also loves anything pink, has requested a special set cut from some pink...

I have the TS 3650 that I added an Incra fence system to. It's been a work horse. Yes, a bit underpowered for cutting dense 8/4 lumber, but I can...

Dense neighborhoods often have adjacent houses built with their garages adjacent to one another specifically to counteract house-to-house sound...

Dewalt says 1/8" is the minimum thickness their planer will handle. Likely you would have to take very thin cuts to minimize lifting of material by...

Exactly what my local sawmill told me a couple months ago. Said prices were about to go up again. I wanted to buy WO (RS/QS) for a project this...

That table top is beautiful Jim. The grain match is dead on. I always like a family connection to the piece. I'm also looking for an excuse to...

Thanks all. After cuting the rough lumber down to manageable lengths, the board lengths varied from about 18" - 24". About 50 boards if I...

I had heard that the Salton Sea was formed by a flood of the Colorado River.

Those are pretty! Excellent work Mark. +1 on the window.

I like Dwayne's idea of a nice lathe. And lay in a stash of exotic lumber - pink ivory, cuban mahogany, ancient khari, yellow heart if you can find...

I try to avoid or disable all automatic renewal options. I think all vendors must offer the option but some vendors are getting pretty sneaky about...

Interesting. The Jenny compression bits from Cadence Manufacturing have notes in the feed and speeds page to use ramping if possible.

Really wish Lee Valley would open stores in the U.S. :( But I'm sure there's a really good reason they don't.

Nice reference! Thanks for posting the link Tom.

Too much leaf litter can smother grass. Some is good to mulch up into the lawn, especially if you have heavy soil (clay). I mow back and forth, so...

No apology needed. I found the information you and Jim provided valuable. A Vcarve test drive is on my to do list. Just need to get thru this...