Rob Sack
Contributor

If I can't get the bit out by hand, I re-tighten the collect nut by hand, slide a 1/4" or 1/2" open end wrench, depending on the bit shank size, onto...

When I built my shop, all my electrical was surface mounted EMT. Over the years, I have also moved and/or upgraded machines. With the EMT, any...

Just checked today with two of my suppliers. The Blum slides that are coming in are being used to fill orders placed 5 - 6 months ago.

As a follow up to my initial post, Amazon just delivered the Drill Doctor 750. It works perfectly. Although it wasn't cheap and it would have taken...

I have used all three methods at one time or another. For my Hitachi planer, which is short, I built a mobile base using beams left over from a...

Another vote for the True Position. In fact we have two. I bought the first one when they first came out and the second at the last AWFS. Granted,...

I did see that on line. The one from Helmreich Joinery looks to be more effective and cost-wise, there wasn't much difference. The cost of the...

Helmreich Joinery Bemboka, NSW, AU

You might want to consider Jorgensen parallel clamps even though they are not being made by the original Jorgensen Company. The "re-issued"...

I would bite the bullet and buy the Oneida. I have a large Murphy-Rodgers for all my machinery, but when I added a 37" wide belt sander, I decided...

Thanks for the suggestion. I found a company in Australia that has beautifully simple attachment specifically for the Blum Minipress. It's on its...