Register
Help
Remember Me?
What's New?
Forum
New Posts
FAQ
Calendar
Community
Groups
Albums
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Articles
Blogs
Donate
Sponsors
Friends of the Creek
Advanced Search
Member List
Rob Sack
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Rob Sack
Contributor
Find latest posts
Find latest started threads
View Articles
View Blog Entries
Mini Statistics
Join Date
10-09-2008
Last Activity
Today
11:38 AM
Recent Visitors
The last 10 visitor(s) to this page were:
Aaron Inami
,
Adam Grund
,
Andrew Joiner
,
Daniel Smith
,
Gordon Dale
,
Jack Frederick
,
joe vaughn
,
Matt Day
,
Richard Young
,
Rick Schubert
This page has had
5,061
visits
Tab Content
Rob Sack's Activity
About Me
Tab Content
All
Rob Sack
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
03-24-2024,
12:54 PM
Rob Sack
replied to a thread
Rail and Stile Orientation
in
General Woodworking and Power Tools
I believe it was James Krenov who would run his rails full length and in the case of a pair of doors, the rails came out of one length so that the...
see more
6 replies | 389 view(s)
03-17-2024,
12:25 PM
Rob Sack
replied to a thread
Drawer slides and Allen wrenches
in
General Woodworking and Power Tools
Go for the KV 8405 or the Accuride equivalent. Same slide but with 1 inch over travel.
see more
10 replies | 899 view(s)
03-13-2024,
9:18 PM
Rob Sack
replied to a thread
Suggestions please
in
General Woodworking and Power Tools
Why not set up a drilling jig and drill 1/4 inch holes at the ends of each piece. Drill countersinks on the top and bottom pieces to accomodate a...
see more
7 replies | 898 view(s)
03-13-2024,
11:56 AM
Rob Sack
replied to a thread
Please recommend a wipeon dining table finish.
in
Project Finishing
First off, I am a huge fan of wipe on finishes, especially on walnut, and have been using them for years. I have pieces I built back in the nineties...
see more
6 replies | 863 view(s)
03-02-2024,
1:30 PM
Rob Sack
replied to a thread
Recommended Clear Spray Finish for White Oak Cabinets
in
Project Finishing
I am not sure where you are located, but I get it from a local supplier in Reseda. CA. I believe they have national distribution. They usually have...
see more
23 replies | 2666 view(s)
03-01-2024,
10:15 PM
Rob Sack
replied to a thread
Recommended Clear Spray Finish for White Oak Cabinets
in
Project Finishing
I've been using Clear Acrylic Topcoat from Centurion Wood Coatings for years on light woods as well as red and white oak. It won't amber. It sprays...
see more
23 replies | 2666 view(s)
More Activity
No More Results
No Recent Activity
About Rob Sack
Basic Information
Statistics
Total Posts
Total Posts
426
Posts Per Day
0.08
General Information
Last Activity
Today
11:38 AM
Join Date
10-09-2008