You could certainly use dyes, etc., to emulate the tone of a specific piece of white oak, but you'd want to choose a species that's going to provide...
Seal with Anchorseal (you can get it by the gallon on Amazon) and as Izzy recommends, get it sawn as soon as possible so you can stack and sticker in...
Yea, I agree. The shipping on my slider in late 2022 from Georgia to Pennsyltucky for about 1000 lbs was $1200 and that was with terminal pickup, not...
These are well known phishing payment scams. DO not respond. DO not click on any link "in" the message. If you are concerned about a "payment" go to...
This case can then sit on a shelf..until a Project comes along that needs chisels...then it can sit down on the end of the bench, where I can access...
Sadly, three panels...so one complete cabinet and one half. But the recovery worked just fine and I slapped myself up-side my head to insure I don't...
David, if you do a ton of narrow component sanding, then yes, the smaller 125mm/5" format is going to be easier to keep things flat. But in general,...
Married; 4 sons, none of them care about woodworking
Location:
Tomball, TX (30 miles NNW Houston)
Interests:
Woodworking
Occupation:
Owner of Tomball Bowl a 32 lane bowling alley.
Signature
Scott
Finishing is an 'Art & a Science'. Actually, it is a process. You must understand the properties and tendencies of the finish you are using. You must know the proper steps and techniques, then you must execute them properly.