I have the 10" 7480... it still has the dip in it near the throat plate (top is aluminum).
Not a problem when using a Crosscut sled. Problem is when...
Good info to have (not that I have any tattoos).
A few years ago I asked the tech what would happen if I had permanent eyeliner and needed an MRI on...
I would take it apart and replace the bearings unless I was positive they weren’t done recently.
Cleaning up the dt ways might be just what’s needed...
There’s another wood movement condition to consider. Where the piece is sitting is there direct sunlight on on side during the day is it by a window....
Doing that would actually create a smaller saw than any job-site saw with the motor hanging out the back, retain the accruacy and most of the mass. ...
Ive worked in the construction industry since 1984. Roofing was my main trade. I have fixed or restored many historic building in So Cal. Including the Getty museum in Malibu and the Central library in Pasadena that was damaged from the Northridge earth quake.Just to name a few.
I am also a vested Union Carpenter looking forward to collecting my hard earned pension.