No More Results

6 Visitor Messages

  1. Hi Brian, I'm glad to help as much as I can. You can try timing all the posts. You'll have to be careful when tightening them so they din't turn, and be sure t get them plenty tight or they could rotate after the machine is in use.
    I assume when the posts are tightened up you'll place the carriage on top and turn the "nuts" on the posts to get the threads engaged. You could measure from the carriage to the bed to make sure all four corners are level to each other. You'd have to measure at each corner and compare the measurements.
    If you need any other help don't hesitate to ping me.
  2. View Conversation
    Jerry, thanks for your help with my dewalt planer. May I ask another ? I got 3 of the 4 posts loose. Can't break the 4th loose. Can I line up flats and thread of the 3 to the fixed one? Flat with thin/beginning cut of thread faces towards bed are at about 2 o clock looking down on the fixed post. I assume all 4 posts should have the same orientation towards the bed? Thanks again for your help. Brian
  3. View Conversation
    Jerry, this is what I want to do . It is a masterpiece. Check out REMBRANDT's posts in this link.
  4. View Conversation
    Jerry, sorry I haven't answered sooner... the way saw mill creek lets you know you have a message isn't very visual... let's chat on email. My email is

  5. View Conversation

    I haven't been up in WI to long but I know where peshtigo is. I bought my Powermatic 3520B fro a guy there..

    Thanks for the note back. Wish u were closer as I'm looking for a few woodworking buds to hang out with and to learn from.

    Didi you go to the woodworking show in mlilwaukee. I went and you didn't miss anything if youo didn't go.

  6. View Conversation
    Hello Jerry,

    I have a note you tried to send me a message but my box was full.. Please email me instead... that works much better. I'm new to Green Bay and need some sources for wood...

    Who do you use? What part of town do you live in? I'm in Astor Park near the two hospitals at Webster and Mason St.

Showing Visitor Messages 1 to 6 of 6
About Jerry Bruette

Basic Information

Date of Birth
May 7, 1960 (64)
About Jerry Bruette
Millwright/Maintenance Mechanic


Confidence: The feeling you experience before you fully understand the situation


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
11-02-2022 9:06 PM
General Information
Last Activity
Today 6:44 PM
Join Date

1 Friend

  1. Steve Schlumpf Steve Schlumpf is offline


    • Send a message via MSN to Steve Schlumpf
    Steve Schlumpf
Showing Friends 1 to 1 of 1