mreza Salav
Contributor

I have used sliding dovetails but in much smaller cross-grain applications and with glue. These joints are not forgiving at all and slightest change...

No failure on the doors, built like tanks! but it would have been a lot faster/easier to use dominos. I would go 14mm for full size doors.

I had some 31 interior doors to make for our house (1 3/4" maple) and didn't pony up to buy it. BIG mistake. Now I have one and it's excellent and...

Have a 3HP ICS and certainly have not experienced this in any way or form. Maybe managed to slow it down while cutting some 8/4 maple aggressively...

I use the saw dust of the same wood mixed with epoxy. I use west system and first wet the wood/hole with pure epoxy then mix enough saw dust to make...

And with that you just added one more thing to watch on top of this thread!

Your blade is not parallel to the fence (at least not in 45 degree) or your jig is not held tight against the fence all along. Adjust the tail end...

What is that huge slab on picture #4? Bubinga?

I have a Rolair VT25BIG which is rated at 6.5CFM at 90psi. Small and can be wheeled around. Very happy with it. It's identical to a similar Makita...

Nice stack of wood. 5-6 years ago when I was on the hunt for wood to build an exterior door I came up with a guy about an hour from me who was...

I always drain (air and water) the tank after each day of use and leave the valve open. Next time I want to use the compressor close the valve and...

Try to escalate it higher in the CS department and talk to a manager. The simple fact that what you got is not what was in the show room is grounds...