No More Results

3 Visitor Messages

  1. View Conversation
    i want an extra as im doing a large run of extra lon table legs, and need a long toolrest and extra support. Also i have been annoyed with the old one the small handle for holding the toolpost needs a lot og force to hold the toolpost in place. So i thought to get the oneway as the new primary and to use the old as secondary.
  2. Hi Rasmus,
    Not sure how the 1640 banjo will work on a powermatic. It should, but I'm not sure about the height of the tool post. Have you considered having a square locking plate made for you PM banjo. I use several lathes that have the round type that are on the PM and all of them lock less secure than my 1640.
  3. View Conversation
    I want to get a replacement banjo for my 3520 and was looking at Oneway. and steve slumph suggested that you might be able to help me.

    i was thinkin that the one for the 1640 would fith i hight and length of posts on th toolrests.
Showing Visitor Messages 1 to 3 of 3
About Jack Mincey

Basic Information

About Jack Mincey
I'm 47 years old and love turning. Been turning some since 1974, but just got serious about it 3 years ago.
Cullowhee N.C.
Fishing, Hunting, Woodturning
High School Shop Teacher


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
06-15-2011 3:23 AM
General Information
Last Activity
01-11-2021 4:48 PM
Join Date

4 Friends

  1. brian watts brian watts is offline


    brian watts
  2. Mark Hazelden Mark Hazelden is offline


    Mark Hazelden
  3. Nathan Hawkes Nathan Hawkes is offline


    Nathan Hawkes
  4. Steve Schlumpf Steve Schlumpf is offline


    • Send a message via MSN to Steve Schlumpf
    Steve Schlumpf
Showing Friends 1 to 4 of 4