View Profile: Larry Frank - Sawmill Creek Woodworking Community

Tab Content: All; Larry Frank; Friends; Photos

Older Activity
09-16-2023, 8:04 PM

Larry Frank replied to a thread help on scroll saws in General Woodworking and Power Tools

There are some scroll saw forums that can really help you. Scroll Saw Village is one of the best. I have a Hegner and use it a lot. I think a...

see more

6 replies | 414 view(s)
09-15-2023, 7:16 AM

Larry Frank replied to a thread Amazon's Tracking - HA,HA,HA! in Off Topic Forum

I have had good luck with Amazon shipping until recently. There have been two orders which are now days late and seem lost. I tried to cancel but...

see more

12 replies | 836 view(s)
09-11-2023, 7:13 AM

Larry Frank replied to a thread Lubing My Table Saw in General Woodworking and Power Tools

I agree that regular WD40 may not be a lube. But, the OP referenced a different product that was a silicone dry spray and is a lubricant.

see more

29 replies | 2217 view(s)
09-10-2023, 8:30 PM

Larry Frank replied to a thread Lubing My Table Saw in General Woodworking and Power Tools

I see quite a few comments about not using WD40 and I agree. The OP asked about using WD40 quick drying silicone. I see no issue using it on the...

see more

29 replies | 2217 view(s)
08-31-2023, 8:02 PM

Larry Frank replied to a thread Parts aren't flush with pocket screws? in General Woodworking and Power Tools

I prefer my corded drill for pocket holes. It does have higher.speed than my Milwaukee or Makita cordless. It drill faster and easier. But each to...

see more

16 replies | 1300 view(s)
08-30-2023, 8:20 PM

Larry Frank replied to a thread Sawstop Patent Ending ? in General Woodworking and Power Tools

I do not know if the blades are trashed. But, I am not going to take the risk. It is not unreasonable to believe the brazing of the tooth could be...

see more

94 replies | 10635 view(s)
08-29-2023, 8:31 PM

Larry Frank replied to a thread TS sled 1 vs 2 runners in Shop Made Tools and Machines

I use one bar and it is the Incra Miter Slider on my Sawstop PCS. It slides easy and tight in the slot. Typically, I use the sled for shorter...

see more

20 replies | 6941 view(s)
08-24-2023, 7:53 PM

Larry Frank replied to a thread Sawstop Patent Ending ? in General Woodworking and Power Tools

Methinks most companies have profit as their primary concern. There is nothing wrong with that.

see more

94 replies | 10635 view(s)

No More Results

Larry Frank
Contributor

Mini Statistics

Recent Visitors

Basic Information

About Larry Frank

Statistics

Total Posts

General Information

Larry Frank Contributor

Mini Statistics

Recent Visitors

Basic Information

About Larry Frank

Statistics

Total Posts

General Information

Larry Frank
Contributor