Cameron Wood
Contributor

Probably work OK. Medium canvas, stretch and staple in the rabbet, the cover with trim strips. Dampen the canvas, and it will tighten as it dries.

Happy sawing.

Adjust with the head up. There may be a detent- push harder to get past the 5˚ point.

Any fences out of the way? cutting head in up position? Check for wood chips lodged, preventing movement.

+1. I've had good results making stair stringers from 3/4" plywood- 12" rips, stagger end joints, glue and clamp with sheetrock screws, which are...

Are the vents supply registers for the home forced air heating system? There are some issues if so.

I've done that endless times, never had an inspector take issue.

Did you ask if she irons her clothes on that table edge? ;)

https://www.homedepot.com/p/The-Plumber-s-Choice-Shielded-1-1-2-in-Transition-Coupling-Connects-Cast-Iron-Plastic-or-Steel-to-1-1-2-in-Copper-or-1-1-4...

I agree with Lee. It doesn't matter which of those is stronger if they are both stronger than the cleats. As Kevin says above, 2x6s on edge would...

Seems like it must be something in the art realm, since their so many sizes. Maybe for detailing ceramics on a turntable, or other decorative...

Looks handy, if slightly exposed.

I don't believe 23g pin nails come that long. Seems like not enough to me, but try a sample.

Yes, I snagged a couple of those the last time I had blood drawn.

How are figure 8 fasteners going to cause the edges of a table to curl up? The focus on this makes no sense to me. If the wood was quite dry, and...

I have good results with a wire wheel, but better in a bench grinder, which spins much faster.

Got another one. This is a recent machine made hammer- even has a bar code sticker, but a decent oak handle, & 24 oz total weight. I'll let is...

No. 200 amp service is not generally needed and was discouraged for a time but is appropriate if natural gas is not used. Many electrical loads,...

They can't all be pristine and dust/shaving free! here's mine- currently, and early on at this location (major fixer house) in 2010. Seventh...

1/4" staples are OK, but don't hold that well because the crown is rounded so they punch through thin material like 1/4" plywood. They also tend to...

Definitely get an air compressor. I've had really good result with this- very quiet, not quite the capacity for continuous nailing, but not far...

Common nails are .148, that gun will not take those. What did your predecessor use?

That weighs 16+ lbs vs about 9 lbs for comparable air one. It will probably last a small fraction as long (I recently sold a Hitachi one over 30 yrs...

I just screw 2x4 blocks to a sheet of plywood, usually for the inside radius. Allow for a liner piece if needed. Only takes a few minutes to strike...

IME, It's a waste of time looking for router bits to match period mouldings. Beyond a simple bead, or a stepped round over, it's just not likely...

That looks like an expensive PIA- read the reviews. I would use Thoroseal. There are Youtubes showing the details. The light, neutral color is...

I never much liked redwood burl stuff, and I lived in the thick of the time & place of it. Whatever is disliked about live-edge & epoxy coated was...

Or with wheels for a pony keg!