Dylan ritterbeck
Member

Thank you Dave. I'll give that a try. Paul, thank you. I'm trying to avoid that but if necessary, we will add a drawer for the chessmen. But...

Dave I'd be happy to send it to you but you need to be a contributor to send pm's. Since you have a 360 I'm sure your machine was pre-adjusted at...

I know zero about RD Works but if that happened on my laser I would look at the colors I used for fill and outline. Most domestic machines require...

I would try newer version of Job Control. I'd be surprised if you found a version that old as there wouldn't be much need to keep it. The latest...

If you have Helix drivers and firmware loaded you should be able to check the machine using a usb cable on your pc. With that you can check the x-y...

Glen There is a white paper on adjusting air assist. You can try to get it from Trotec or if you'll pm your email I'll send it to you.

I'm pretty sure Speedy 300's come with pre-installed air assist with the compressor being located at the front of the machine under the right hand...

In addition to Bill's tips, take a hard look at the x axis bearings. Years back I had this issue on my Universal.