Brad Shipton
Contributor

That's a fit to be proud of. Great tenacity.

Such an interesting difference of opinion. Some of us are gadget guys, some are not. Do you need them? Absolutely not. You can go look thru the...

Good job sourcing your problem. I always sigh a great relief when I finally find a problem. So many times I forget to write down the changes made...

Open the gcode, and find a couple of known dimensions. You should be able to find some dimensions and do a little math to see if the code is...

Mark, my point in mentioning the temperature control was not to suggest it was a consideration for our work, but rather to suggest that our material...

Mark, you would have to show me how you derived your figures as both our machines are built on the same frame using similar techniques. We are both...

8 - 10 thou is quite respectable for the machines in our class. Companies that do better than that use CMM equipment to setup their rails and...

Those are very nice and seems like a good way to consume scraps. Thanks for posting

Mine has been sitting in the Byrd box for 10years. My 4hp machine struggles with 12" wide boards, and I have to be careful when planing Cherry,...

Larry, i am not sure how much day to day use you would find for this. Locating the connectors in the middle of a panel is about as fussy as dowels. ...