Brian Rohde
Contributor

Ronald...thanks for the link. I read your post and others about the helical head conversion and think I'll stick with the HSS knives for now. I...

Fiinally had the courage to take it apart and access the three bolts on the table lip, loosening them slightly and tapping the table lip until it was...

I am nervous about taking the cutter head off. It looks that I loosen the belt, take the rabbeting ledge off, take the hex screws out of the bearing...

I recently bougth this jointer and it has had this problem since I acquired it. The infeed and outfeed are coplanar and the table lip is about .015...