Holmes Anderson
Contributor

I can't watch it until later tonight but am looking forward to it. A shower is the only justification for pressure water in a boat that size and just...

Not to be snarky but I've seen the "Art of Boat Building" channel and it takes some big conkers to use such a pretentious name for a channel that...

I would test the centrifugal switch like somebody else mentioned. If the centrifugal switch is stuck open then the motor will not be able to generate...

Lots of good advice in this thread. I use an older D4R like yours. The e-bush is not for these older models. Based on that single photo I would say...

Up here the prices have changed/inverted in some strange ways. I often buy from Highland in Brentwood, NH, which someone already suggested to the OP...

Absolutely, ash is the wood to use right now. It is currently less expensive than pine here in New England. This is a great time to building a bench...

Depends on your expectations and how you use your planer. The 20" capacity is very useful if you run glued-up panels. As some have pointed out, the...

Keegan, If you have been in the biz or the hobby for 30+ years then you have had your calipers, straight edge and feeler gauges on a lot of...

If you search this forum and others like it you will find many more complaints about poor quality machining and parts and shipping damage with the...

Interesting. Why did he reach over the blade rather than pull the sled back toward himself?

Why wasn't the guard in place? Not a through-cut? Most of the people I know who have been injured in TS accidents would not have been injured if they...

Does Northfield worry about being undersold by the cost of some knives? A 12" Northfield jointer sells for about $20k and, although the design is...