Holmes Anderson
Contributor

The study says that the temps at the bottom of the roof are 23 degrees F higher at peak with spray foam than ventilated. It also says that there is a...

I guess i'm late to the party on this thread but you may have more to worry about than choosing insulation. If that was unconditioned space and you...

I've seen the table made from a single layer of MDF. The negative rake blade will reduce the tendency for the saw to suddenly move toward the...

Thanks so much everyone. Just the info I was looking for. I've been using the original guides for close to 20 years so I didn't dislike them enough...

The Salice F70s only have two slotted openings - one at the far front and one at the far back. I guess I could slotify some of the round holes.

https://www.microjig.com/collections/mj-splitter

That's normal. There are four leveling screws and a pin at the back of the plate to prevent it from being kicked out by the blade and a thin jammed...

Maybe someone could recommend a rail square for the OP. I haven't used one and they seem too short to get an accurate cut across a full sheet but I...

I don't think the Makita saw or track is the problem. That isn't a surprising amount of error for trying to square up a panel along that length of...