Chase Williams
Contributor

Mini Statistics

Join Date: 10-28-2020

Last Activity: Today 12:55 PM

Avatar

Tab Content: Chase Williams's Activity; About Me

Tab Content: All; Chase Williams; Photos

Older Activity
Yesterday, 2:08 PM

Chase Williams replied to a thread Trotec Speedy 300 seems to skip a tooth in Laser Engraving General Topics

Which version of Job Control are you using. I checked and in JC 10.7.1, there is a firmware that is specific to 8011 Speedy 300, 10.36.50.2. I would...

see more

14 replies | 2092 view(s)
12-19-2020, 11:48 PM

Chase Williams replied to a thread Trotec Speedy 300 seems to skip a tooth in Laser Engraving General Topics

If it is the motor, below is what I believe is the replacement motor, it would not be difficult to replace on your own if you are handy, but after...

see more

14 replies | 2092 view(s)
12-19-2020, 11:40 PM

Chase Williams replied to a thread Trotec Speedy 300 seems to skip a tooth in Laser Engraving General Topics

Have you made sure that there are no apparent issues when doing the full travel of both the x and y axis? The only things that I can think that could...

see more

14 replies | 2092 view(s)

No More Results

Statistics

Total Posts

Total Posts: 16

Posts Per Day: 0.20

General Information

Last Activity: Today 12:55 PM

Join Date: 10-28-2020

Home Page: http://www.SharpMediaLLC.com

All times are GMT -4. The time now is 6:30 PM.

Powered by vBulletin® Version 4.2.5
Copyright © 2021 vBulletin Solutions Inc. All rights reserved.