mike stenson
Contributor

Those must be newer than a year.

They make attachments for drill presses to hold the chisels. I have one, I'd be happy to give away.

How is posting here giving a manufacturer feedback? Serious question.

I feel like this is the same either way in Arizona.

My wife wasn't a rural carrier, nor was a friend of ours. Both had that issue on 2010ish Subarus. I remain unimpressed with them in general.

That sounds like a stuck caliper, which was a potential issue on the Subaru's I worked on.

I also have magports. I couldn't use the woodpeckers or woodcraft ones because, as mentioned, 120mm tools. I don't find the alignment to be a huge...

I can tell people who don't work in a manufacturing, or product development, industry. Nothing to sell, and you got no company. This isn't planned...

Depends on the bias. My GTi wore rears much faster than front, by design. I think the OP isn't hitting the brakes as hard, or heating them up, the...

I'll take sealed, non-serviceable, bearings and having to replace them once for every 8th time I'd have to clean and repack non-sealed bearings.

This was awesome, when I had straight knives!

I sharpen my hand tools several times during use. Basically, I keep my stones out when using them. Reestablishing a bevel, removing a nick etc, with...

I find my tormek to be great for sharpening turning tools. Things like chisels and plane irons, faster with a normal bench grinder and stones....

Large power tools? Millwrights.

I agree, I only use the domino in a vertical fashion when I've got a fence clamped across the workpiece. But that means I'm registering against the...

So, dangerous for all but collectors.

Yea, this is why I generally break down lumber with a handsaw or a jigsaw.

jointers are probably the most dangerous machine in the shop. Accidents are not as common as others, but the results are always really bad.

I can't make it any clearer then.

You guys are talking about different conductors.

Here's your translation. Adjust the knife protrusion using a gauge. Max 1,1mm

This. The fastest way to flatten a board is with a saw.

Store em vertically (keep the dust off), keep em oiled. No problem. I like a saw plate that reflects, personally.

Agreed. I'd drill a hole in a metal plate with your drill bit and make my own dowels.

So let's just abandon any prevention method possible. Got it. 'social darwinism' at it's finest.

Nope, kind of inherent in the technology. Some systems have less delay than others, but it's always there.

It's not a bed, it's a settle. I'll be providing the seat frame to an upholsterer.

The actual cost of the warranty is significantly less than what they charge for it. That's what he's referring to. That is, you can get it for...

I predict this thread will go the same way as it did the last couple times. There's a used market.

I'm guess this was the CPSC one that got way out of control?