Myles Moran
Contributor

I rubbed the dust port of mine with a dryer sheet. I also opened up the hood and rubbed the exhaust impeller in it. That seems to be the big source...

The only other tool that comes to mind is a soldering iron for putting the electronics together. Using a prebuilt neck means you shouldn't need...

I definitely agree. I also enjoy having a well shaped volute at the end, and that's not readily available unless you're making it yourself. That...

If you're not interested in fiddling with the frets and such, you can buy a prebuilt neck. I bought one from warmoth that was great quality and set...

I'd agree with Lisa's assessment. Unless you're rough cutting a lot of pieces before milling, the majority of graded lumber will be between 6" and...

I have a shelf in the basement right outside my shop for the big pieces. I also have a big tote in my shop for the smaller pieces. Seeing that my...

My first thought was a stake pocket, but given the dimensions you're looking for I don't think that will work because those are usually sized for a...

Yes because I rarely will have the fence off the cast iron when using the saw, so the laminate top is more of a storage table for me until I need to...

I have the 36" 3HP. It has handled everything I've thrown at it without flonchit, but I'll admit that currently the worst of that is 8/4 walnut and...

I have a lot of the screws woodcraft sells. All the woodworking screw, none of the self drilling points. Unlike the cheap wood screws home depot...

My bench is 1/2" lower than my tablesaw. That way with proper outfeed support it will hopefully never catch anything coming out of the saw. I don't...

Yoder is great, but a heck of a drive for something I can get somewhere closer. I went there to get some.5/4 hickory I couldn't find anywhere else. ...

It is actually finished. 3 coats of arm-r-seal on everything but the top that has 5 and got rubbed out. Unfortunately my dirt cheap phone doesn't...

Thanks Jamie, I think that'll be the ticket. If I dig through my scrap pile in the shop I'll probably be able to find a piece from that same board...