• Robert Dicke's Avatar
    09-08-2019, 11:58 AM
    Robert Dicke replied to a thread Piece cracked in Turner's Forum
    So next time put a clean cut in both ends and seal the chunk of wood before turning. Then make sure I have enough time to turn the vase inside as...
    17 replies | 779 view(s)
  • Robert Dicke's Avatar
    09-08-2019, 11:38 AM
    Newbie here- I just got my first lathe up and running and was playing around with a chunk of ash. I turned a rough vase shape and when I came back to...
    17 replies | 779 view(s)
  • Robert Dicke's Avatar
    08-23-2019, 7:27 PM
    Paul is correct! It took a pickle fork to remove the live center from the shaft and then a 5 lb mallet and a bench vise to pound out the taper. Which...
    7 replies | 531 view(s)
  • Robert Dicke's Avatar
    08-22-2019, 11:32 PM
    So this is my tail stock ram with live center. I donít see that the center comes off. Are you saying I need to fine a second ram without a center on...
    7 replies | 531 view(s)
  • Robert Dicke's Avatar
    08-22-2019, 6:52 PM
    Just inherited an old Delta Rockwell 46-525 lathe from my dad. It had a spur center and a live center for the tail stock but I was hoping to get a...
    7 replies | 531 view(s)
No More Results
About Robert Dicke

Basic Information

Statistics


Total Posts
Total Posts
5
Posts Per Day
0.18
General Information
Last Activity
09-08-2019 11:58 AM
Join Date
08-22-2019