Register
Help
Remember Me?
What's New?
Forum
New Posts
FAQ
Calendar
Community
Groups
Albums
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Articles
Blogs
Donate
Sponsors
Friends of the Creek
Advanced Search
Member List
Thomas McCurnin
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Thomas McCurnin
Friend of the Creek
Find latest posts
Find latest started threads
View Articles
View Blog Entries
Mini Statistics
Join Date
03-18-2019
Last Activity
Yesterday
2:04 AM
Avatar
Recent Visitors
The last 10 visitor(s) to this page were:
Dave Crabbs
,
glenn bradley
,
Gregg Thomas
,
Jeff Clode
,
Jim McCue
,
John Barfield
,
Lloyd McKinlay
,
Patty Hann
,
Scott Snyder
,
Von Bickley
This page has had
6,525
visits
Tab Content
Thomas McCurnin's Activity
About Me
Tab Content
All
Thomas McCurnin
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
03-12-2024,
1:44 AM
Thomas McCurnin
replied to a thread
Mixing Epoxy
in
General Woodworking and Power Tools
I've used System 3 for more than a decade and have never noticed much of a difference when varying the resin to hardener ratio. Perhaps it might...
see more
12 replies | 952 view(s)
03-11-2024,
12:58 PM
Thomas McCurnin
replied to a thread
Mortising Hardwoods with Mortiser !
in
General Woodworking and Power Tools
I still doubt they are truly sharp inside and out. Sharpening a hollow chisel mortising bit is more than a couple swipes on the outside with a...
see more
35 replies | 2527 view(s)
03-11-2024,
12:23 PM
Thomas McCurnin
replied to a thread
Would you buy a house if Former Owner finished the Basement?
in
Off Topic Forum
Did the owner add a bathroom? Later, if they decide to do add a shower, update a service panel, or do something else that requires a permit, and...
see more
29 replies | 1789 view(s)
03-10-2024,
7:00 PM
Thomas McCurnin
replied to a thread
Mortising Hardwoods with Mortiser !
in
General Woodworking and Power Tools
I have never had any problem with a similar (Delta) mortiser. I suspect your bits are not sharp. Often, they are simply not honed fine enough out...
see more
35 replies | 2527 view(s)
03-06-2024,
5:38 PM
Thomas McCurnin
replied to a thread
Mortise and tenon projects
in
General Woodworking and Power Tools
I agree. A small bedside or coffee table is a good way to start. This table was a beginner project where I went to woodworking school in Waco,...
see more
27 replies | 2482 view(s)
03-05-2024,
10:57 PM
Thomas McCurnin
replied to a thread
Advice needed
in
General Woodworking and Power Tools
Well, if it doesn't work, then it has to be sold "for parts." I doubt I would pay much over $50. It's 3 phase which is incompatible with my shop,...
see more
9 replies | 734 view(s)
02-26-2024,
12:37 AM
Thomas McCurnin
replied to a thread
Miter Saw Tried to Bit Me
in
General Woodworking and Power Tools
How does the Fastcap stick work? It seems similar to any push stick. I don't think this was the saw's fault. It does sound like perhaps you...
see more
15 replies | 1352 view(s)
02-21-2024,
10:38 PM
Thomas McCurnin
replied to a thread
Medicare Advantage vs. Traditional Medicare
in
Off Topic Forum
We concluded that the Advantage Program has a big advantage, but if one doesn't like it, it nearly impossible to switch back as pointed out above. ...
see more
29 replies | 2086 view(s)
02-21-2024,
12:37 AM
Thomas McCurnin
replied to a thread
Looking for Recommendations on Custom Tool Storage Boxes-Chests
in
WorkShops
Yes, I need the tools to be stored under a work surface at about 35" so a 44" cabinet, while nice would waste space.
see more
6 replies | 1450 view(s)
02-20-2024,
5:01 PM
Thomas McCurnin
started a thread
Looking for Recommendations on Custom Tool Storage Boxes-Chests
in
WorkShops
I have a 6 foot run of 40 year old metal Craftsman Tool Drawers-Tool Chests under a laminate top, which has served me well. It is 33" high plus the...
see more
6 replies | 1450 view(s)
02-17-2024,
6:09 PM
Thomas McCurnin
replied to a thread
More Questions about Luxury Vinyl Plank Flooring
in
Off Topic Forum
I'd ask the manufacturer of the vinyl flooring for its recommendation.
see more
29 replies | 2427 view(s)
More Activity
No More Results
No Recent Activity
About Thomas McCurnin
Basic Information
Age
73
About Thomas McCurnin
Biography:
Avid carpenter and woodworker since 1966
Location:
Los Angeles, California
Interests:
Hiking, Woodworking, Antiques
Occupation:
Retired Lawyer
Signature
Regards,
Tom
Statistics
Total Posts
Total Posts
958
Posts Per Day
0.52
General Information
Last Activity
Yesterday
2:04 AM
Join Date
03-18-2019