View Profile: David Zaret - Sawmill Creek Woodworking Community

Tab Content: All; David Zaret; Friends; Photos

Older Activity
11-29-2019, 8:23 PM

David Zaret replied to a thread MM 16 bandsaw shutting itself off in General Woodworking and Power Tools

check the starter. there is a little dial inside the switch that indicates max load before tripping, and i had a similar issue as you're describing....

see more

12 replies | 365 view(s)
11-19-2019, 10:45 PM

David Zaret replied to a thread Tersa Carbide Knives in General Woodworking and Power Tools

given the price of the blanks, i don't think it's worth the risk. the carbides definitely have a different geometry than the M+, and obviously...

see more

20 replies | 894 view(s)
11-19-2019, 10:29 PM

David Zaret replied to a thread Tersa Carbide Knives in General Woodworking and Power Tools

dave, i couldn't use HSS - the diameters didn't work out. i bought some blanks from unimerco, they were cheap. if i recall, i paid ~$125 to...

see more

20 replies | 894 view(s)
11-19-2019, 7:59 PM

David Zaret replied to a thread Tersa Carbide Knives in General Woodworking and Power Tools

agreed with Joe - i also tried the kanefusas, and though they were fine, given the price, and the fact that they can't be sharpened, it doesn't...

see more

20 replies | 894 view(s)
11-19-2019, 2:55 PM

David Zaret replied to a thread Tersa Carbide Knives in General Woodworking and Power Tools

i run carbides in both of my tersa machines - 4 knives in the planer, and 2 knives with two blanks in the jointer. yes, they are very expensive -...

see more

20 replies | 894 view(s)
11-18-2019, 12:41 AM

David Zaret replied to a thread Martin T27 Questions in General Woodworking and Power Tools

sure - tomorrow i'll grab pictures and get my settings and post something. thanks for the collective help, i'm just getting used to the machine. do...

see more

9 replies | 489 view(s)
11-17-2019, 3:07 PM

David Zaret replied to a thread Martin T27 Questions in General Woodworking and Power Tools

i checked our machine.. it was dead nuts from the factory. 23.3mm spindle height to the base, and 15.875mm with the aigner fence. martin doesn't...

see more

9 replies | 489 view(s)
11-16-2019, 8:23 PM

David Zaret replied to a thread Martin T27 Questions in General Woodworking and Power Tools

Anthony - we have a new T12, same electronics as the T27, but a few options missing. can you describe what you did to zero the spindle to the fence?...

see more

9 replies | 489 view(s)

No More Results

David Zaret
Contributor

Mini Statistics

Recent Visitors

Basic Information

About David Zaret

Contact

Statistics

Total Posts

General Information

David Zaret Contributor

Mini Statistics

Recent Visitors

Basic Information

About David Zaret

Contact

Statistics

Total Posts

General Information

David Zaret
Contributor