Zac Martin
Contributor

That would be awesome Patrick, thank you! How did you attach the base to the top? Also I can't wait to see the chairs you come up with!

Patrick, I absolutely love this table, particularly the base. My wife has put a new dining room table on my list and I believe I will be...

Very Nice! It is incredibly satisfying to take a rough-sawn piece of lumber and process it into something beautiful. Make sure to post a picture of...

Hey Lisa! I was born and raised up the road in Millcreek! It's neat to see so many folks from PA here.

Welcome Rajesh! Tons of nice folks and great info here. Enjoy!

This past week I continued to wrestle with my dust collection set up, and I have approximately 1 million tiny sheet metal cuts on my hands to prove...

I like Melamine since the dust blows off nice and easy. If you do end up using them for glue ups or something like that, the squeeze out can be...

Smart idea! I'm definitely going to be more mindful of it moving forward.

This was my first thought. A tupperware lid or something fell back there. This happens all the time with my garbage can/recycling can pull out in...

haha. Share some pictures before you take it apart!

Thanks for the info, Pat!

sounds like you are off to quite a good start! I don't have any experience with the SS yet, though I did ask someone else here about the PCS vs ICS...

Oh man, I'm jealous, that looks awesome! I realize we are in two different parts of the country, but what is the ballpark cost to have this done?

Beautiful work, I love it!

Accomplished? I don't know how much this accomplished but I did take down my cobbled together dust collector off my wall for reevaluation and...

https://thewoodwhisperer.com/ The Wood Whisperer... Marc has been doing awesome woodworking content on youtube for many years.

Hey Mike, So I'm guessing its just a bit heavier, maybe a beefier trunnion? I'm sure I'll do a lot more research when I get to closer to...

Hey Bob, Thank you! Overall I'm pretty happy with how it turned out. I had purchased a pickup truck bed full of offcuts from a guy on craigslist...

the 3HP PCS or ICS? I wonder how much of a difference there is between the two that would warrant an additional $1000 or so for the ICS.

Thanks Bruce... you should see the other half of the garage! :D

Hey Bob, which saw do you have? I'm going to upgrading my ridgid 4512 at some point in the nearish future, and pretty sure I'll be going to one of...

I've sent my end grain cutting boards through the planer before with no issues, but ymmv. If you do, take very light passes and glue a sacrificial...

How in the world did I miss this?? I'm probably on the grizzly site 5 times a week, and it didn't come up in the shopping section of google when I...

Tigerwood, bloodwood, and Bolivian walnut?? OK now you HAVE to share some pictures of this kitchen when it's finished! Happy early birthday, btw!

I'm in a bare concrete floor garage shop now... would love to get a nicer floor in there at some point like you guys. Question for those in a...

Hi Alex, Yes I am aware of the difference... it is the 1741H that I purchased/cancelled. Thanks though. And I purchased through a place...

that's a pretty neat idea!

Thank you Cary... I checked out the G0857 but it is more expensive than the 1741 when you take into account the 1741 had free shipping... and the...