Joe Hendershott
Contributor

I would never want to give up the miter saw just for that reason. I use it 99% just to cut rough lumber dow, It's a lot easier to slide an 8/4 piece...

My recent experience was with SCM but wasn't exact;y smooth. Perhaps the same with Hammer I think it might be because the bulk of sales is with much...

I'll be at the shop this morning and will measure.

Exactly. Even it it's not in the US yet they have machines already with some options. Those options bought by themselves are pricey, even by Minimax...

There are literally thousands of posts here on that same subject. I'll just add that you use the correct tool for the job, not one tool will do...

I bought some micromesh after reading a few posts here and have to say I really like it. In the past I used the different 3M pads or steel wool with...

On my 14BX it does the same, i still apply more tension.

Here in Atlanta the big lumber suppliers have engineers at the lumber yard that you can consult with for free and can calculate proper spans and...