Ron Selzer
Contributor

I have one in the garage, 2 in one part of the basement, and installed two in a garage at work. Definitely better than an incandescent lamp even 300...

I see the value and versatility in a sliding saw now, however if I would have known about them when I upgraded to the SawStop ICS 5hp 36". I still...

As some one said once: "The difference between a man and a boy is the price of his toys". After trying two different drum sanders and getting...

Glad it turned out to be exactly what you wanted. Was not aware that any jigsaw stop instantly ron

I would bend a 1/4" 45 deg angle facing out on the bottom edge to keep water from creeping back under the copper, might consider using 100% silicone...

I like the look of that front a lot, pulls are very nice also. have a dresser sitting downstairs pushed aside for over a 1 1/2 yrs that will end up...

I have a D3 Leigh and have no idea of why or how you use paper shims. The DR4 I have looked at and someday would like to have it as there are a few...

Years ago I subscribed to New England journal of Light Construction (https://www.jlconline.com/magazine/) they always had a lot of good information...

anyone else having radio inference from led? replaced/added led lights to basement shop and radio went from about 1/2 fm stations to none Settled...

Follow up after you use the Makita and let us know how it meets your needs thanks Ron

How about $2.49 for 16gb with reasonable shipping based on how much you buy?...

Or about an 1 1/2 hr. further north in Ohio as I am getting frustrated with redoing my dust collection and would tear it all out and install that...

springs do nothing for holding the knives in place. Ron

Porter Cable 690's work for me have two dedicated to the Leigh dovetail jig. Getting harder to get now about a year or so ago they were severely...

I currently use extensions for edge jointing on a Jet 6" jointer. have two section of bowling alley lane about 9"x7' cut a rabbet across the end and...

A good auctioneer will be the best for you based on what you posted. Question is who that auctioneer is? Good luck Ron

Grizzly bought South Bend and kept the name going Ron

Bought it yesterday on Kindle and read it. Found it a very good written book about Shiraz and his life. Definitely a hard driven man who has...

Jeff please post back after you get it all set up and report on how these pieces are working for you. I have an ICS 5hp 36" fence with mobility...

Thanks for posting this looks like it is free on kindle will check it out and read it Ron

go with 4 330lb(5") casters, one in each corner with 6 casters almost always will have the crate teetering on the middle set, why the expensive tool...

Might reconsider cutting it in half to cut into 1/3 and 2/3 this would give you multiple widths instead of just 1 width Ron

I would try silicone caulking to glue a metal pie pan down to it Ron

"fire the switch ‘buzzing sound’." that typically is a contactor not pulling in tight, pull the coil out and clean any rust, dirt, etc off of it...

not up on the IVac system but have a automated dust collection system here that triggers on/off of tools running. Added a switch to the controls that...

Personally you need to jump all over that one Extras/upgrades fence router plate mobile base No rust very nice clean shape, wait and someone...

I strongly recommend the Sawstop be on the ICS mobile platform with a fold down roller for out feed table. mine has been that way for five years now...

I run blade stabilizers because I have them as long as they don't interfere with depth of cut. Do have different sizes, bought them 35 years ago when...

I have that basic configuration for about three years now, mine is stationary with 2" scd40 pvc piping around the workbench(5 ports) and the shop...