Alex Zeller
Contributor

It's most likely going to be a bust. Even if everything happens just right the meteors are expected to be moving very slowly. This means they...

Sounds like a fuel issue to me. Might want to check the fuel filter. In my saws it's inside the tank and doubles as a weight to get the fuel hose...

Where did you get the wood? I've made a few segmented turnings out of short cutoffs. But I realized that these cutoffs usually were the ends of...

It's hard. A few years ago one of the on-line auction houses had a commercial Rockwell radial arm saw (the one built like a tank) about 5 miles from...

I'm not great at it but I could make it in Fusion 360. It just took a few you tube instructional videos. I've never used Sketch Up but with Fusion...

I have both a corded (Dewalt), cordless (Milwaukee 18v), and an air impact wrench (aircat). The corded one is the weakest by far. It'll barely...

So here's where I'm at. The oval is made but I haven't routered a detail around the outside edge. yet. Here's the final design I came up with and a...

I have the Lenox Woodmaster B in 1" 1.3 tpi. I got it for my 19" Grizzly 514. I hadn't decided on which carbide blade I wanted and if I did...

Another word of caution is if you position them out at the edges of the bucket it doesn't take too much weight on just one side to tip over your...

I've had mine for several years now and there was a few things I needed to finish. First was the pressure bar. It's a powder coated orange color. ...

I glue both sides as I like to work the PVA into the wood. The exception is if I can move both pieces around some to help spread the glue. If...

I would buy a lead paint test kit. Most places wouldn't touch it if there's lead paint on it. Depending on what type of person you are you don't...

It's hard to tell just how steep the land is. You did say there was only one building site without lots of work. To me that's kind of a turn off...

Be careful of the new aftermarket FOBs. They are usually very cheap quality. I had one and within a year one of the switches came off the circuit...

Back in the day when you wanted to unlock your car you would pull your key out and stick it in the keyhole. For those down south it may seem like...

I second this. If a tooth on the hole saw bites in it forces the flute of the pilot bit into the metal in the side of the pilot hole. That'll cause...