I agree with Patrick about using a pencil to draw a light cross hatch pattern and sand until it’s gone. Do that every grit. Clean thoroughly between...
Take a closer look at the tightening bolt and see if there is an idler sprocket that it pushes against. The shaft for it may be stuck and a light tap...
I have a Gomad tilting spindle with sliding table similar to the pic in the previous post. If you look at the pic you can see a handle just above and...
The domino probably doesn’t cut the mortise in the exact center of the edge so you need to mark all the faces so you are indexing from the same face....
Find latest posts
View Articles
View Blog Entries
