View Profile: Steve Jenkins - Sawmill Creek Woodworking Community

Tab Content: All; Steve Jenkins; Friends; Photos

Older Activity
01-14-2021, 3:24 PM

Steve Jenkins replied to a thread Veneer Replacement Technique in General Woodworking and Power Tools

I would make a new top. Veneer on mdf then edgeband with oak. To flush the solid I use a hand held belt sander but I’ve been doing that for a lot of...

see more

17 replies | 357 view(s)
01-11-2021, 7:15 AM

Steve Jenkins replied to a thread Table saw - Mortiser - Sliding stop builds. in General Woodworking and Power Tools

Did you send this to MicroFence? I’m sure Richard would like to see it.

see more

17 replies | 564 view(s)
01-08-2021, 8:08 PM

Steve Jenkins replied to a thread Thick Wood Pattern Cutting in General Woodworking and Power Tools

I try to avoid straight router bits whenever possible. I use either spiral or shear bits. Much less tear out.

see more

24 replies | 924 view(s)
12-29-2020, 4:59 PM

Steve Jenkins replied to a thread Tell us a CLEAN joke! in Off Topic Forum

At the end of his physical the doc asks if there is anything else. Man says his wife is really hard of hearing but he doesn’t know how to tell her....

see more

109 replies | 12912 view(s)
12-28-2020, 7:31 PM

Steve Jenkins replied to a thread Question about mitered MDF in General Woodworking and Power Tools

If you have a good biscuit joiner number “0” biscuits will work

see more

4 replies | 316 view(s)
12-24-2020, 12:20 PM

Steve Jenkins replied to a thread Best approach for drying air from air compressor in General Woodworking and Power Tools

I put a drip leg and moisture trap right after it

see more

50 replies | 2386 view(s)
12-23-2020, 7:30 PM

Steve Jenkins replied to a thread Best approach for drying air from air compressor in General Woodworking and Power Tools

I had a moisture problem years ago and purchased an after cooler from Grainger. It looks like a car radiator with a fan blowing through it. Works...

see more

50 replies | 2386 view(s)
12-18-2020, 7:35 PM

Steve Jenkins replied to a thread How to fix an already glued up 2 2x12 fir boards that are cupping? in General Woodworking and Power Tools

Sounds like the edges may not have been square. I’d rip the joint apart the rejoint the edges and reglue. When you clamp alternate clamps above and...

see more

17 replies | 908 view(s)
12-18-2020, 7:12 PM

Steve Jenkins replied to a thread How would you solve this self inflicted wound in General Woodworking and Power Tools

How about using the 15” slides and set them back from the drawer front. Attach a spacer to the drawer bottom to fill the gap between the front of the...

see more

9 replies | 749 view(s)

No More Results

Steve Jenkins
Contributor

Mini Statistics

More 2 Friends

Adrian Anguiano

Jim Rimmer

Recent Visitors

1 Visitor Messages

Basic Information

About Steve Jenkins

Signature

Statistics

Total Posts

Visitor Messages

General Information

2 Friends

Adrian Anguiano

Jim Rimmer

Steve Jenkins Contributor

Mini Statistics

More 2 Friends

Adrian Anguiano

Jim Rimmer

Recent Visitors

1 Visitor Messages

Basic Information

About Steve Jenkins

Signature

Statistics

Total Posts

Visitor Messages

General Information

2 Friends

Adrian Anguiano

Jim Rimmer

Steve Jenkins
Contributor