View Profile: Steve Jenkins - Sawmill Creek Woodworking Community

Tab Content: All; Steve Jenkins; Friends; Photos

Older Activity
Yesterday, 7:42 PM

Steve Jenkins replied to a thread I'm a Bandsaw Idiot: Please Help Me Install This Blade. in General Woodworking and Power Tools

Don’t forget to back off the tension all the way before you try putting on the shorter blade. Also after you back off the tension grab the top wheel...

see more

13 replies | 438 view(s)
Yesterday, 12:18 PM

Steve Jenkins replied to a thread 24, 46, and 80 grit sharpening stones in Neanderthal Haven

When I was a kid Dad had to cut and patch our concrete floor in a couple places. To smooth the areas after drying he gave me a carborundum block...

see more

8 replies | 599 view(s)
03-22-2023, 12:10 PM

Steve Jenkins replied to a thread Auction Shaper - T45 Griggio in General Woodworking and Power Tools

to check for 90° I just use a good 12” metal ruler and clamp it on edge between two spacers on the spindle then measure with a dial micrometer at...

see more

42 replies | 1986 view(s)
03-22-2023, 11:00 AM

Steve Jenkins replied to a thread pot rack question in Design Forum

I’m not a fan of hanging pot racks where you can hit them. I put mine under the cooktop. It is just a cabinet with two doors so I put a bar across up...

see more

7 replies | 405 view(s)
03-20-2023, 12:27 PM

Steve Jenkins replied to a thread What 10’ sliding saws should I consider? in General Woodworking and Power Tools

If you can wait I suggest going to the AWFS in Vegas. You will be able see and touch many different ones.

see more

32 replies | 1772 view(s)
03-19-2023, 6:29 PM

Steve Jenkins replied to a thread Source for parts for a file cabinet in Design Forum

Amazon search for file frame

see more

7 replies | 497 view(s)
03-08-2023, 9:03 AM

Steve Jenkins replied to a thread lighting suggestions for built in in General Woodworking and Power Tools

I’ve done shelves with luck lights and just drilled a hole from the back edge of the shelf through to the puck hole. 3/4” shelf no problem.

see more

18 replies | 1352 view(s)
03-01-2023, 1:40 PM

Steve Jenkins replied to a thread Looking to replace a Northfield 12" jointer? in General Woodworking and Power Tools

I’m a big fan of Dispoz-A-Blade and been using them for a lot of years. Don’t know the type of steel but it’s very good

see more

17 replies | 1572 view(s)
02-27-2023, 12:57 PM

Steve Jenkins replied to a thread Homemade Vacuum clamp in General Woodworking and Power Tools

For the gasket you can use closed cell foam weather stripping

see more

17 replies | 1299 view(s)

No More Results

Steve Jenkins
Contributor

Mini Statistics

More 2 Friends

Jim Rimmer

Adrian Anguiano

Recent Visitors

1 Visitor Messages

Basic Information

About Steve Jenkins

Signature

Statistics

Total Posts

Visitor Messages

General Information

2 Friends

Adrian Anguiano

Jim Rimmer

Steve Jenkins Contributor

Mini Statistics

More 2 Friends

Jim Rimmer

Adrian Anguiano

Recent Visitors

1 Visitor Messages

Basic Information

About Steve Jenkins

Signature

Statistics

Total Posts

Visitor Messages

General Information

2 Friends

Adrian Anguiano

Jim Rimmer

Steve Jenkins
Contributor