Zachary Hoyt
Contributor

For me I can shave off a 2-3 day beard with the Braun foil shaver, if it's longer I have to use the trimmer attachment to knock off most of the...

I have a Braun foil shaver that works well for me. I have been using it for about 8 years and it still is working, though the trimmer part on the...

The one with the handle is guaranteed to fail unless it is kept in a place with consistent humidity, which is not usually the case in a kitchen. ...

If you just need it to curl up a bit I would try putting it on a concrete floor for a day or so. This time of year the air is very dry inside and...

I have had a 19-38 since spring 2018. The only time it will burn is when the sandpaper gets damaged or badly worn out. The 'intellisand' box is...

Nothing that I know of. The way to control heat is by finding the right speed setting and the right feed rate for the job in hand, and having a...

I have bought and sold hundreds of things on eBay over the years, I don't sell much now but that is because I am selling new instruments I have made,...

I got a second bandsaw last year, and now that I have had two I wouldn't want to go back. Building musical instruments is my livelihood, so I am...

I agree that getting a lathe is a good idea, my first one was traded to me for about $100 worth of twig chairs, and was a nice old machine, not very...

Could you put an overhead beam of some sort over the gateway and have the gate hang from it, like the way a bifold closet door works? Seem to me...

The finished wood is very pretty, and thanks for the explanation about necks. It seems like the neck-body joint would be quite strong the way you've...

It looks great. I didn't realize that solidbody guitar necks were glued on. What kind of joint is used? I had had the impression that they were...

I bought a used small compressor/inflator machine at an auction 10 years ago or so. It has a sticker on it that says "drain tank daily to prevent...

It takes me about 5 minutes to mark the fret locations and another 5 to cut them, so I imagine that your CNC is faster than that, besides the...

I guess I've been lucky. I bought about 20 or more 36 grit 4x36 sanding belts from the dollar store, they were old stock and are several years older...

If the top part is metal then you can take them to a fire equipment shop to be inspected and refilled, some of ours are quite old but our insurance...