Zachary Hoyt
Contributor

I think this saw will be hard to price. It has a lot of valuable features, but the X5 series are not very highly regarded, at least by some people. ...

Sears made some pretty poor quality motors too. I burned up 3 or 4 Craftsman table saw motors in older saws that I bought, and then I finally bought...

I had a DeWalt 733 planer that would trip the overload protection on the motor all the time. It was very annoying. Finally I decided that since I...

I understand the importance of avoiding spontaneous combustion, though I didn't watch the video. I'm a little puzzled by the whole concept of...

Just to add, I often run mine on low speed, which is around 700 RPM. This is nice for sanding end grain without burning.

You could use a snow rake to remove it mechanically from the ground. Then you wouldn't have to worry about killing other plants that you want to...

I used to turn banjo rims on my Shopsmith. I'm 7 feet tall, so finally I made legs from 8/4 ash that were more than a foot taller than the sheet...

I've had the strap wrench kind and they are harder to control, and the strap slips off sometimes on skinny lids. It would be easy enough to make a...

The best one I have had, and now the only one I have, is the OXO version. I got mine for 50 cents at a thrift shop, but it's very handy and probably...

I sold my 733 in September and sent the dust hood with it as far as I can remember. I have 3 sets of knives for it that have no nicks but are a bit...

Up till a year ago I sold hard and soft maple for $1 a board foot, but it wasn't kiln dried. 12/4 is an oddity so I would expect it would be more. ...

I would try it for a bit by just cranking the blade down below the table and putting a piece of plywood on top of the table saw to pretend to be a...

I heard that snake oil is the best. A salesman told me.

I print self adhesive labels with an HP 1010 Deskjet printer that I bought for about $20 around 10 years ago. I've printed many hundreds of labels...

I use a dustpan on my 1940s Unisaw. I open the door and clear it out before it gets too deep. If your saw is anything like it I think there is not...

It looks great, and very innovative. Good for you.

I have no HVAC experience or knowledge, and found it was pretty easy to install a 12k Mr Cool myself. I got quoted $4-5k by a contractor for some or...

Maybe you're thinking of UShip.com? I've not used them, but some people have. Also I have been told you can ship things from store to store with...

I have a push reel mower and try to remember to mow the lawn before it gets too tall. At our former location it took me about 2 hours to mow, here...

eBay is my preferred source for wood screws and machine screws. It takes a bit of searching but there are some good deals.

I was lucky when I had 200 amp service put in to the house here. I had to provide the meter main, the conduit mast up the side of the house with the...

I would have preferred to use the existing 100 amp breaker as that would have saved me $20 or so to buy a breaker, but since he's the person in...

Especially not when it's running.