I've been trying to figure out the wiring needs for the VFD to run the 3 phase motor on the bandsaw I've been posting about lately, and have run into...
Tom, I have used urethane on my previous two 18" bandsaws and have been happy with it. I have seen your posts about bandsaw wheel questions but have...
I use aluminum plate for bandsaw throat plates and it would also work for a router table insert, I think. It's easy to cut and sand with woodworking...
Today I had an idea that in retrospect seems obvious. Once I had the idea it only took about 15 minutes, some scraps, and 7 screws, and now I have a...