Zachary Hoyt
Contributor

I've had the strap wrench kind and they are harder to control, and the strap slips off sometimes on skinny lids. It would be easy enough to make a...

The best one I have had, and now the only one I have, is the OXO version. I got mine for 50 cents at a thrift shop, but it's very handy and probably...

I sold my 733 in September and sent the dust hood with it as far as I can remember. I have 3 sets of knives for it that have no nicks but are a bit...

Up till a year ago I sold hard and soft maple for $1 a board foot, but it wasn't kiln dried. 12/4 is an oddity so I would expect it would be more. ...

I would try it for a bit by just cranking the blade down below the table and putting a piece of plywood on top of the table saw to pretend to be a...

I heard that snake oil is the best. A salesman told me.

I print self adhesive labels with an HP 1010 Deskjet printer that I bought for about $20 around 10 years ago. I've printed many hundreds of labels...

I use a dustpan on my 1940s Unisaw. I open the door and clear it out before it gets too deep. If your saw is anything like it I think there is not...

It looks great, and very innovative. Good for you.

I have no HVAC experience or knowledge, and found it was pretty easy to install a 12k Mr Cool myself. I got quoted $4-5k by a contractor for some or...

Maybe you're thinking of UShip.com? I've not used them, but some people have. Also I have been told you can ship things from store to store with...

I have a push reel mower and try to remember to mow the lawn before it gets too tall. At our former location it took me about 2 hours to mow, here...

eBay is my preferred source for wood screws and machine screws. It takes a bit of searching but there are some good deals.

I was lucky when I had 200 amp service put in to the house here. I had to provide the meter main, the conduit mast up the side of the house with the...

I would have preferred to use the existing 100 amp breaker as that would have saved me $20 or so to buy a breaker, but since he's the person in...

Especially not when it's running.

I bought a 735 in late summer when my old secondhand 733 began having more issues. I've been running a 10' length of 4" black plastic dust hose into...

Just a suggestion-it might help to put WANTED in the header so that people will realize you're looking to buy.

In my new workshop I used a used 100 amp panel from the house. I only had 50 amps feeding it. My electrical inspector told me to backfeed the panel...

On my 19-38 I have had no problem using just my fingers to change abrasives, after the first couple of times. At first it was a bit confusing...

I bought a 19-38 in 2018 and it has been great. The clip is not hard to use after the first few times getting used to it. I haven't used the older...

I don't know about that saw, but I will say that a Unisaw is much nicer than a contractor's saw, having had both. I got mine for $500+ with the...

I burned all the slabs from our sawmill in the wood gasification boiler at the farm for about 15 years. Slabs are great to burn, but they burn up...