Jack Frederick
Contributor

Two books that will delight and inform you. Dan Holohan’s “Pumping Away” & “Primary-Secondary Pumping Made Easy”. Dan writes in a way that the...

Some time back, Bill Carey, on one of the favorite tool threads suggested the Grammercy Sliver Kit. On that recommendation I purchases the kit and it...

Flat Down, stickered, properly stacked and in my dry dry CA shop for 2.5 yrs Rough sawn and i don't know i didn't cut it Enough to create the warp...

500 and 1000# will surely demonstrate the definition of inertia, so slow and steady wins the race here. I have an assortment of iron pipe up to 2" I...

I built a lumber rack for the long stuff a few months ago and have a similar set-up to Glenn's, but mine is vertical orientation. For the overflow or...

Life is a humbling experience. Thanks for sharing and glad you are ok.

When I built my shop with 10’ walls I set plywood vertically. All of my 30 & 50 amp plugs are down-fed. In the six yrs I’ve had the place I’ve only...

Difficult to say as to size, but I would remove the flare fitting and put a 1/2 or 3/4” normal cap on the IPS thread.

Send them a note. while considering the RT for my saw I felt the photos were poor, contacted them and suggested that they have simple clear pics or...

I’m with Tom on this. Of course this all depends on the work you do, but SS offer a fold down table. Also I break sheet goods down on the track saw....

I cut my rails down on the 52”. Once I pulled the table to the right I marked the rails in place with a carbide scribe as I simply didn’t want to...

Thank you for the suggestion, Mel. As life happens, having Xmas with both of my daughters families and both of the girls realizing that I wasn’t...

Curious if anyone has broken the handle on the typical rat tail handled Bessey clamps. They seem ubiquitous in shops and I have the same grip problem...

I have the 3hp PCS and it has handled anything I’ve needed it to cut up to 10/4 WO handily. As Alan pointed out, blade dependent. As you have the...

Thanks for that Fred. I hadn’t thought of that. That inside hole is pretty rough, but I’ll check it out further. ...And Merry Christmas to you and...

Dynamic saw make metal cutting blades. I use my Evolution chop saw or the Portaband. I cut the rails on my SS with a Milwaukee M12 Sawzall with a...

Speaking with a friend yesterday, he suggested that given the size of the pieces that perhaps the best use for these four pieces would be as legs for...

Laguna is very proud of their accessories, which is why my 14 BX rolls around on an aftermarket base and I do not have their lights. i am not sure...

I am the weak link in the chain. I do not work late into the PM or evening. I am morning energy and as the day progresses I start to miss her, so,...